1
Technical Support / Re: adsb (out) not showing on Vector
« on: March 22, 2024, 10:41:04 am »
To answer the last post, the FUNKE transponder was new 2 years ago - I had to exchange the old one which did not support adsb. There is no warning of GPS failure in the transponder. I can check the GPS data input using the setup mode but that is only available with the transponder in standby. So I have checked it on the ground only. I will check the cable continuity but it is a very simple single cable into the Trig and Funke plugs.
Flew yesterday and adsb exchange tags the flight as sourced from adsb data but nothing shown on vector. After flight spoke to Pete Pengilly about the issue and he is going to put his test set on it next time he is at our base.
Thanks for all the help
John
Flew yesterday and adsb exchange tags the flight as sourced from adsb data but nothing shown on vector. After flight spoke to Pete Pengilly about the issue and he is going to put his test set on it next time he is at our base.
Thanks for all the help
John