Hi
Just a quick post - my first flight with the PAW aerials and GPS mounted remotely. The PAW itself is dropped into the px side bulkhead pocket and the aerials sucker mounted to the px side of the windshield, with the gps velco'd to the coaming...
I would post some pics, but couldn't work out how to from my iPhone !
My list of bits and bobs is as follows:
2 x PAW dipole aerials from Pilotaware. Although using the dipole of that length is not ideal for receiving ADSB and Mode C/S it seems these signals are relatively strong, and seems to work fine, from here:
http://pilotawarehardware.com/product/dipolecouplet-antenna/1 x SMA female to MCX male adapter
image2.JPG
to allow the connection of one of the dipoles to the dongle, from here:
https://www.ebay.co.uk/itm/262496365620 1 x MCX right angle M - F connector
image3.JPG
to allow connection of the other dipole to the PAW aerial connection, from here:
https://www.ebay.co.uk/itm/111677577302 1 x pack of 20, 20mm suckers from here
20mm Round Button Suction Cups (20 Pack)
https://www.amazon.co.uk/dp/B008B65K2I/ref=cm_sw_r_cp_api_FJZoyb3P5AWF12 x patented, bespoke dipole-to-sucker adapters (made from some scrap wood from our old staircase ....)
image4.JPG
1 x USB extension lead for the GPS,
image5.JPG
from here
https://www.ebay.co.uk/itm/370782294942 Anker 13400 battery pack, from here:
https://www.amazon.co.uk/dp/B012SRLKZ6/ref=cm_sw_r_cp_api_zYZoyb5B01KBDAnd in use, if a little untidy, the PAW unit being out if the way in the px side bulkhead pocket..
image6.JPG
Suggestions how to simplify / improve this further most welcome...
My next challenge is to find a decent enclosure for the PAW that allows all the connections to be from one end as that would make it easier to connect up the aerials and the gps. Suggestions welcome :-)
Regards
Andy