Good Evening All,
I'd appreciate some practical help introducing my PAW to my TRT800 for ADB S out. I have the Funke document instructing that the serial data line is connected to pin 12, and that ground is pin 0 or 9. Software version is o.k.
I've been advised that the usb to serial converter cable required is FTDI USB-RS232-WE-1800-BT-0.0 CABLE, USB A - RS232, SERIAL CONVERTOR from Farnell. This cable has 6 output wires, 4 more than required by the transponder.
My question is: If this is the correct cable, which wires are to be connected to pins 0 and 12 on the transponder? Looking at the cable tech data sheet it's black to 0 (ground) and orange to 12 (asynchronous data output), but I'd be grateful for supportive advice from a guru
Thanks
David D