I was on a flight yesterday. 2 pilotawares in the same aircraft. Units positions in almost the same place on the rear seat and one not getting the same number of Mode C/S contacts. Even off other aircraft in the circuit. I think antenna may of been loose so will want to investigate that further. The really anomaly from the flight was that skydemon kept drawing our aircraft on the ground on my unit when getting position data from pilotaware. I did some tinkering while PAX...restarting PAW, connecting, disconnecting, location services (worked fine) vs flarm. I wish I'd tried restarting my ipad but didn't. Anyway I plugged in my unit to the ethernet this morning to download the track logs and see if there might be any clues but my unit got corrupted somehow and and wouldn't boot.
Formatted the SD card and installed 20160708 on it (hadn't previously downloaded 20160820....doing that now but its taking forever to download). Unit boots OK and I'm now connected to the admin page using 192.168.0.100 over the ethernet from by desktop PC. But now I click on
http://192.168.0.100/updates.cgi > Check for updates and the
http://192.168.0.100/check.cgi page just hangs on Checking for Updates. Same think over the wifi from the ipad.
