There is a strange messages in the start up process towards the end on the 19th Dec build.
Mounting File System READWRITE
Mounting File System READONLY
TRX-SER: ERROR!!! comms buf=' '
Probably looks onerous, but actually nothing to worry about, I think I may remove some of these errors, they are more for my debug purposes than anything.
This is simply saying communication failed with the new RF Module - which of course it will, because you do not have one yet ;-)
Also pleased to see that this build also works on PI2 (despite including a ARM/ARM7 warning message in the log). Haven't yet tried the ARF in the Pi2.
Thats good, the Pi2 does seem to be working OK for me too, but the recommendation is still PiB+
Someone earlier reported that the USB GPS Global Sat BU-353S4 worked with PAW. It hasn't worked in the previous build or this Dec one. The device shows up as a 'Prolific' device.
Cannot comment on this, I do not have access to one of these I'm afraid.
U-Blox Dongle, and U-Blox G-Mouse have been proven to work well.
Good new configuration menu. I did note that the TX counter on the Pi2 was increasing despite not actually having the ARF unit fitted.
I need to investigate this at some point, somebody else reported this also - I am surprised having looked through the code, will try to investigate.
I have a slightly dodgy USB connection on the RTL unit so it disconnects sometime and consequently the ADS-B detection stops and no further planes are identified. If reconnection is made the RTL unit does not appear to reinitialise and no further planes are detected. Is it meant to restart on reinsertion?
This is a little more trick to handle to be honest.
There may be a method to improve the handling of this issue, but for now, all I can say is 'do not remove the dongle, or you need a reboot'
Many thanks for the feedback - keep it coming ....
Thx
Lee