@peter.seddon
Hi Peter
I am sorry I am totally confused from your last post.
The instructions should read
$ sudo /root/mount_w.bash and
$ sudo /root/mount_ro.bash
This is not correct, the commands are
$ sudo /root/mount_
rw.bash and
$ sudo /root/mount_ro.bash
Thanks Lee, yes I finally worked it out after reading the instructions again
I am unclear what it was that you worked out ?
What was it that you needed write access to perform, my understanding was you had done the following:-
1. installed the latest release (onto a formatted SD card) from a ZIP installer
2. re-run PilotAware-OGN.config.bash to re-enter your groundstation details
I cannot see where you went wrong in these 2 steps, or where you needed to modify the disk from ro -> rw ?
Could you elaborate each of the steps you have taken so we can understand if there is an underlying problem ?
Thx
Lee