Author Topic: SOLVED! - Software for Pi B+ and new RF Bridge  (Read 4707 times)

dougblair

SOLVED! - Software for Pi B+ and new RF Bridge
« on: May 25, 2016, 11:10:19 pm »
I have my " old " PAW that was reduced to "ADSB only" post state of nation address. I also have a new RF Bridge.  Is there a software version for this combination ? 
« Last Edit: May 26, 2016, 05:41:28 pm by Admin »

Paul_Sengupta

Re: Software for Pi B+ and new RF Bridge
« Reply #1 on: May 26, 2016, 12:45:51 am »
The software works on either the Pi 2 or the B+, and auto senses to configure the new features if on the Pi 2. It should "just work" on a B+.

EricC

Re: Software for Pi B+ and new RF Bridge
« Reply #2 on: May 26, 2016, 03:34:32 pm »
My new Bridge arrived this morning.
Apart from modifications to the case worked first time.
Good strong signal on my comms receiver on 869.4

Very many thanks to all involved in this great product.

EricC


Admin

Re: Software for Pi B+ and new RF Bridge
« Reply #3 on: May 26, 2016, 05:26:44 pm »
Good strong signal on my comms receiver on 869.4

Hi Eric,

Hopefully 869.525 to be exact  :D
It is smack bang in the middle of the 869.40 - 869.65 part of the 500mW SRD spectrum

Thx
Lee

EricC

Re: SOLVED! - Software for Pi B+ and new RF Bridge
« Reply #4 on: May 26, 2016, 07:53:02 pm »
Agreed centre of the ETSI BAND.

Just for interest the best setting is WFN. squelch turned to min.
NFN no reception.
AM fainter max squelch.