Connecting TRX 1500 to Aircrew for using Flarm modul

[DY691]

Hello
I am installing a TRX 1500 module in my machine. I already have an Aircrew in my machine connected to a Rosetta.
The TRX 1500 has a Flarm module and I want to connect it to the aircrew via the RJ45 socket.
Unfortunately there is no RJ45 output in the TRX 1500.
the link is made through a DB15 socket I enclose the manual the links are described on pages 16 17 18
Thank you for your advice
Sincerely
Guy Ferrer

[steveu]

Can't see much of a PilotAware element to this.

Looks like you'll need to buy or make up a cable connecting port 3 (basic) or port 2 (clever) on your TRX 1500 to your Aircrew via the correct pins (5, 6, 7) on your RJ45 on your Aircrew. That's DB15 to RJ45, will need soldering and a crimp tool.

Then configure the baud rate in the Aircrew device.

You've already got ADS-B direct and FLARM via ground stations in the PilotAware AFAICT, just connect USB from Aircrew to PAW and configure.

Or am I missing something?

[DY691]

Thanks Steveu
For your help, I fly in France where we do not have ground stations to receive the flarms, I take advantage of the fact that the trx 1500 has a flarm module to receive it on the Aircrew module...
I actually used the port 2 of the trx via the DB15 plug to the rj45 plug using pins 5 and 6.
I did not connect pin 7, the trx is powered by the Rosetta, maybe I should connect it anyway?

[steveu]

Thanks Steveu
For your help, I fly in France where we do not have ground stations to receive the flarms, I take advantage of the fact that the trx 1500 has a flarm module to receive it on the Aircrew module...
I actually used the port 2 of the trx via the DB15 plug to the rj45 plug using pins 5 and 6.
I did not connect pin 7, the trx is powered by the Rosetta, maybe I should connect it anyway?

Not sure why you connected across the RJ45 pins 5 and 6 - this is RX/TX - this doesn't seem right.

If you are sending data from the TRX1500 to the Aircrew using port 2, you would connect the pins 9 (Port 2 TX) and 7 at the DB15 end to pins 5 (RS232 RX) and 7 on the Aircrew. You need a signal ground for the RS232 to work as I understand it.

Pin 7 on the DB15 is ground - this should go to pin 7 on the RJ45.

Be careful - you don't want to short anything out.

Connecting across pins 5 and 6 will not work.

[DY691]

Thanks again for your help
I'm going to try this set up but not for another 10 days, I'm getting my daughter married this weekend  and back home next week
I'll keep you posted on the rest
Best regards
Guy