Rosetta to trigTT2Q

[Jeff Ellwood]

I have just upgraded from a standard pilot aware to a Rosetta, however the trig now has no info to give me my adsb, the usb lights up and the baud rates are correct I think. Any ideas

[exfirepro]

Hi Jeff,

Are you sure you have configured the correct USB Port to ‘Transponder Trig’? Which port have you connected your Transponder Lead to? With the Ethernet Port on the left, they are numbered...

E  1  3
    2  4

Baud rate in both units needs to be the same - i.e. 9600Baud. If in doubt, give me a call.

Regards

Peter

[Jeff Ellwood]

Hi Pete,
Pretty sure I have them the same rate. I spoke to Ashley who said it didn’t matter what you called them so they are set to auto.
I will check the baud rate on both units again.
Regards
Jeff

[Admin]

As Peter says the correct port needs setting as trig
Thx
Lee

[exfirepro]

Hi again Jeff,

When you’re checking, as well as both being the same Baud rate, the Trig gps data input needs to be set to NMEA0183 - though this must have been set previously as it was working. Worth checking again though.

Regards

Peter

[A_Vinning33]

Hello Jeff,

There must have been some confusion there as I said that it should the USB Settings for the port in use should be set to 'Trig Transponder'.
I recall you saying that you had done this over the phone.

Best Regards,

Ash

[PaulSS]

http://forum.pilotaware.com/index.php/topic,1589.0.html

[Jeff Ellwood]

I will have a check of settings tomorrow,
Thanks everyone.
I will report back
Regards
Jeff

[Jeff Ellwood]

Checked all again and changed port 4 name to trig, had a flight and it’s all working
Thanks everyone
Regards
Jeff

[EricC]

Hi Jeff guess the attached is you flight this morning.

[exfirepro]

Hi Jeff,

Thanks for letting us know. Glad you have got it working again.

Best Regards

Peter