Hi all,
I Updated the software per Keith’s recent e-mail request. Then tried out the VRS function with the one OGN SDR connected and all fine for displaying PAW and OGN targets. Then decided to add a spare SDR from my original spare PAW and re-ran the Config script. This hangs indicating that 2 SDRs were found, but “device 0 with serial number 00000001 cannot be found. Most likely the serial number has been altered and the Pi rebooted without running this script. Reboot required”. I try this but config hangs again as above.
If I disconnect the second SDR and re-run the config, it finds the one OGN SDR ID=0 which it says is allocated to OGN/ FLARM reception on 868Mhz.
If I connect the second SDR (with a long body that doesn’t get so hot, with side mounted MCX socket) to my spare PAW it works fine, pulling in ADSB!
Any ideas how I can get the second SDR to work with VRS?
Thx,
Chris