Author Topic: Custom case designs  (Read 4944 times)

alan_d

Re: Custom case designs
« Reply #30 on: March 06, 2018, 02:06:58 pm »
Quick Q - why have option without lugs?

Yes, I mentioned it in the item description. Default option is without lugs. I'll change the photos to show a lug-less version as the primary photo later.

AlanK

Re: Custom case designs
« Reply #31 on: March 06, 2018, 02:57:41 pm »
Ignore me - was thinking lugs were the stand offs for some reason, not the part on the case for mounting  :-[

back to bed for me!

alan_d

Re: Custom case designs
« Reply #32 on: March 07, 2018, 04:35:00 pm »
It will be good to see your design once you get it finished.
Peter

Peter, yours was posted today, hopefully with you tomorrow or Friday.
Attached are pictures of your black case with my PAW bits fitted as well as a version with mounting lugs. I sent you a different lid however as I wasn't happy with the finish of the one pictured below.

Note, you need to spring the case walls apart a little when fitting the Pi/bridge in order to clear the audio socket, while you slide it towards the P3I antenna socket hole.
The case lid is held on with the 4 screws into the Pi mounting pillars, and a block / latch at the fan end - so it needs to slide into place. Carefully check the fan wires aren't pinching on anything.

Let me know how you get on with it and any suggested improvements.
« Last Edit: March 07, 2018, 04:39:41 pm by alan_d »