91
Technical Support / Re: Cannot remove Group-ID to Show Transponder Code
« on: December 08, 2019, 03:40:45 pm »Thanks for the information Peter.
I remain confused.
Here is the extract of the email from LAA Engineering on Friday "...The ADSB status must display SIL and SDA set to 0 (third and fifth digits) and the transponder on mode S outputting a squawk code..."
Is the LAA requesting the impossible withe the squawk code?
C.
It’s the transponder that will supply the squawk, not you manually entering it in PAW.
See below - this is the traffic screen from my PAW a few minutes ago - the top two entries are emitting ADSB and the squawk is shown in the ‘SQ’ column.