Messages

1

Technical Support / Re: Problem Receiving FLARM with Rosetta (in France)

« on: April 10, 2024, 07:29:35 pm »

Thank you for your efforts
My flight on the 6th was to Gap ...not the 7th as it was a Sunday and the restaurant is closed on Sundays...
I can confirm that the following days were ground tests.
hoping that Lee will find an explanation
Thanks again
Guy

2

Technical Support / Re: Problem Receiving FLARM with Rosetta (in France)

« on: April 10, 2024, 06:09:17 pm »

Hello Peter
My last flight near the LFLG satation was on 6 April. I passed almost vertically over the LFLG field at 6500ft to the south at 1002 UTC and passed north again at 6500ft almost vertically over the LFLG field at 1323 UTC.
the distance as the crow flies between LFLE and LFLG is 40km but there is a lot of relief between them
I think that the flights on 7 and 8 April were not really flights but ground tests at LFLE to see if I was receiving gliders flying within 5km of my position ... unfortunately no gliders were reported...
Thanks for your help
Have a nice evening
Guy

3

Technical Support / Re: Problem Receiving FLARM with Rosetta (in France)

« on: April 10, 2024, 10:26:52 am »

Hi
Mac adress/Hostid
B827EB4F4147
Thx

4

Technical Support / Re: Problem Receiving FLARM with Rosetta (in France)

« on: April 08, 2024, 12:22:51 pm »

Hello
some news about the Rosetta
in flight the 4 tabs are green, I receive the adsb (airliners) and some aircraft in S/C mode with the yellow rectangle in red or green with their exadecimal addresses.
on the other hand, still no metars or meteo on the surrounding airfields.
I do get clouds on the radar page.
Still no flarms despite the green gsm link.
see you soon
Guy

5

Technical Support / Re: Problem Receiving FLARM with Rosetta (in France)

« on: April 05, 2024, 09:22:20 am »

Hello Peter
Thanks for your help ?
I started to disassemble the Rosetta (the explanations were very clear, well done).
In fact by opening the top cover the module came by itself I think the 40 pins were badly inserted...I did not go any further and by reinforcing the top module everything went back to normal.
I do have the 4 green tabs???
No gliders in sight this morning. I'll check this afternoon to see if the flarms are present.
Thanks for your help
Have a nice day
Best regards
Guy

6

Technical Support / Re: Problem Receiving FLARM with Rosetta (in France)

« on: April 04, 2024, 10:54:26 am »

Next photos

7

Technical Support / Re: Problem Receiving FLARM with Rosetta (in France)

« on: April 04, 2024, 10:50:37 am »

Hello
I bought a new micro sd card i formatted it then installed the software 20230316 then installed it again in the rosetta unfortunately thePAW remains red...
I am attaching the screenshots and there is still an error message on the logging page.
Do you have any ideas?
Sincerely
Guy

8

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 03, 2024, 05:28:36 pm »

Thanks Peter for the advice
I have read it carefully and you could remove this message so as not to generate any confusion.

i did the startup test on my tv apart a low volt message at the end of the startup with paw login at the end....
unfortunately I still have the red tabs I'm going to reinstall the file 20230316 and I'll keep you posted.

9

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 03, 2024, 11:13:42 am »

Hello Peter
Thank you for your reply. I'm very pleased to learn that there is an ATOM station at LFLG.
Until recently I received the flarms via IGRID on my Dynon HDX wired link rs 232 and wifi on aircrew.
I don't use savefly in flight, it was just a check on the ground to see if it was working.
I have removed the Rosetta from my aircraft in order to check at home that it is working properly. I am at LFLE and there is a large glider centre 3km away,
 For the moment the weather doesn't allow us to see much traffic.
what I don't understand is that until now the P3I has been green
Is there a simple way of checking that the internal transmission module is working properly, given that my skills are limited?
I'll contact you on the ATOM address for the rest.
Thank you and good day
Guy

10

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 02, 2024, 07:20:34 pm »

Thanks for your help
I write to support@PilotAware.com

11

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 02, 2024, 06:00:30 pm »

Thank you Steveu for your feedback
it doesn't seem to come from the antenna,I crossed the 2 antennas and the large antenna the one for 869.5 mhz put in place of the 1090mhz allows to receive adsb the PAW tab remains red even with the small antenna connected to the 869.5 mhz
my skills stop here and indeed a help to see if the internal module PAW is functional would be welcome .... thank you for your help

12

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 02, 2024, 01:38:10 pm »

the last

13

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 02, 2024, 01:35:55 pm »

follow

14

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 02, 2024, 01:32:27 pm »

Previous post

15

Technical Support / Re: Problem Receiving FLARM With Rosetta in France

« on: April 02, 2024, 01:30:04 pm »

Hello
I'm still having problems receiving flarms with my rosetta, but the PAW tab has turned red with P3I red and the barometer red too (see attached photos).
I can't access the metars either, but there's a radar image on the radar page.
I'm in the 20230316 version and I've also tried the beta version 20240205 same thing ...
If you have any idea how to get the information .... thank you in advance