Messages

1

Technical Support / Re: 'no ADSB' error on Trig TT21

« on: January 22, 2020, 01:59:10 pm »

Thanks for your help at the weekend, Peter. It is working well. A great piece of kit. It would be good if the trig manual was a bit more specific in labeling the pins on the plug. It has to be pins 4 & 5, not 5 & 6 as I had them. Only by looking at the block diagram in the back does it all become clearer.

2

Technical Support / Re: 'no ADSB' error on Trig TT21

« on: January 19, 2020, 12:43:40 am »

Thanks Peter. Grant will have finished with the aircraft at around 12.30, so will be able to look at it then.

3

Technical Support / 'no ADSB' error on Trig TT21

« on: January 18, 2020, 09:24:05 pm »

Our new PilotAware unit is working well and showing traffic. However having connected it to the Trig transponder using the recommended Farnell cable, I am constantly getting a 'no ADSB' error message on the transponder in the air. The transponder is OK on the ground, but when airborne and when I assume it is being interrogated by secondary radar it shows the error. I am pretty sure that I connected to the correct pins on the transponder plug, pins 5 and 6. (Peter says 4 and 5, but 4 and 6 are both ground connections so hopefully that is OK). I will go to the airfield this week and double check my connections.