1
Technical Support / Re: Flashing LEDs on RS232 classic to Trig transponder
« on: November 17, 2021, 08:51:17 am »
Have checked the data sheet and all it says is the leds indicate tx and rx does say which colour does what
Show Posts
You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.
Pages: [1]
2
Technical Support / Flashing LEDs on RS232 classic to Trig transponder
« on: November 14, 2021, 06:00:34 pm »
My Trig transponder said not receiving and ADSB out data today whilst flying. Also couldn’t connect to wifi.
Thought it was a power failure to PA but on landing checked and everything seemed ok. Question, what colour should the led in the RS232 cable be flashing? It’s rapid red at the moment.
Thought it was a power failure to PA but on landing checked and everything seemed ok. Question, what colour should the led in the RS232 cable be flashing? It’s rapid red at the moment.
3
Technical Support / Re: FTDI cable
« on: May 24, 2017, 10:18:20 pm »
Absolutely ridiculous that the port numbers are not clearly shown in the instructions.
I have spent all afternoon installing the ADSB lead from PA to my Trig TT21. Couldn't get it to work. But thought that the Spare port was number 4 according to the quick start guide. Will try again later this week to see if I can get it working.
I have spent all afternoon installing the ADSB lead from PA to my Trig TT21. Couldn't get it to work. But thought that the Spare port was number 4 according to the quick start guide. Will try again later this week to see if I can get it working.
Pages: [1]