Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.


Messages - Andyt55

Pages: [1]
1
Technical Support / Re: Pilot Aware - SkyDemon Issue
« on: July 23, 2021, 05:21:54 pm »
We're due to meet up again next week so we'll take screen dumps of both our setups and I'll post them here.

Andy

2
Technical Support / Pilot Aware - SkyDemon Issue
« on: July 22, 2021, 09:50:19 pm »
My friend and I both have a PilotAware in our aircraft.  I have an original PilotAware Classic, but I have upgraded the processor board to a Raspberry Pi 3.  He has a Rosetta.  We are both running the latest version of the PilotAware software.  If we both run up the web browsers on our tablets, connect to our PilotAwares and go to the Traffic tab we both can see each other and P appears in the Mode field.

But when we use SkyDemon and Go Flying/ Use Pilot Aware I can see him and other traffic; he can see other traffic but not me.  This became apparent when flying and our test was with the two aircraft about 20m apart and line of sight between the antennas.

Does anyone have any idea what our issue could be?

Andy

3
Technical Support / Re: Unable to reset SSID
« on: July 07, 2019, 05:39:05 pm »
I'm not quite sure but after a number of reboots of the system it worked and accepted the new SSID.

Andy

4
Technical Support / Re: Unable to reset SSID
« on: July 07, 2019, 05:00:46 pm »
I went to the home page, then clicked on the Network tab.  I then went to the Configure page and back to the Network page.  Changed the SSID to PilotAware-GFJTH and selected Apply which gave the HTTP error.

Andy


Ahh no wait, I think I know what is happening here
The first ever time you go to the network tab - it reboots the network, so you lose connectivity
subsequent times it is OK

Please try it again

Thx
Lee

5
Technical Support / Unable to reset SSID
« on: July 07, 2019, 04:29:24 pm »
I have just upgraded the software on my PilotAware classic to the latest version.

I have entered my licence key and aircraft details and all seems to be working and it confirms that it is version 20190621.

However if I go to the network tab, change the SSID to reflect my registration (by deleting the MAC address and inserting my registration), enter a simple password and select Apply I get a message "HTTP request method not supported".

Am I doing something wrong as the instruction indicate that this is all I have to do.

Pages: [1]