Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.


Topics - Sapper732

Pages: [1]
1
Technical Support / Radio interference
« on: March 31, 2021, 10:12:10 am »
Hi, I am having an issue with constant radio interference when I connect the power supply to my Rosetta. I do have an Anker power supply. I have switched off each of the following in turn, but it does not change anything, Trig21 Strobes gps for ipad aware gps. The only way to cancel out the noise is turn the squelch up on my radio, but then I cant transmit.
Anyone with a magic wand out there who could help please.
Cheers Chris

2
Technical Support / Not picking up adsb out or mode c/s
« on: February 05, 2021, 08:59:34 am »
I have retained the classic so as I could test the adsb out for the BMAA mod, but am finding that all I’m getting is both the Rossetta and classic showing P in the mode section and all zeros in the adsb status, is this because I’m attempting this whilst the aircraft is in the hanger?
Cheers
Chris

3
Technical Support / Connecting RS232 cable to Rossetta
« on: January 30, 2021, 04:54:22 pm »
Hi, just upgraded to a Rossetta, but I’m having difficulty in connecting the RS232 cable for ADSB OUT to a usb socket as other items that are using the other usb sockets are in the way, is there some sort of adaptor? can anyone help please.
Many thanks,
Chris

4
Technical Support / New Pi3b
« on: July 15, 2019, 02:14:40 pm »
Hi, I've just purchased a Pi3b to replace my Pi2 and I believe I have to give you my old and new MAC address so you can give me new license details.
If this is correct do I send details via an email or through the forum and finally how much would it cost?
Many thanks.

5
Technical Support / 3D
« on: July 09, 2019, 11:43:06 am »
Hi, I have downloaded the new software and I can see the config page shows MODE=3D, but when I look at the radar it appears as 2D. Can anyone help please.
Many thanks,
Chris.

6
General Discussion / PAW Classic/Rosetta
« on: July 07, 2019, 11:16:31 am »
Hi, I have the PAW classic and would like to know if the latest software update will give me the same tools as the Rosetta. If not, what is the difference between the classic and Rosetta.
Cheers
Chris

7
General Discussion / Flarm mouse
« on: October 03, 2017, 12:42:55 pm »
Hi, can anyone point me in the right direction as to which flarm mouse I would need to connect to my PAW
Many thanks,
Chris.

8
Technical Support / Wifi connection problem
« on: October 02, 2017, 04:14:25 pm »
Hi, can anyone help me please. With paw powered up I then go into settings on my iPad and select pilot aware wifi connection which in turn shows I am connected I then attempt to connect to 192.168.1.1 and my iPad and my phone state that I have no connection to the Internet.
Can anyone please advise me.
Many thanks.
Chris

9
Technical Support / Connecting Trig21 to PAW
« on: December 19, 2016, 06:38:46 pm »
Hi, can anyone please advise me about how to connect and configure the PAW to my trig21. I have attempted to connect the RS232 cable using the orange and black wires, when connected I have flashing lights at the USB end. I have the PAW Usb set to auto. The trig is set up with NMEA with a speed rate of 4800, but trig shows a warning of no ADS B. I have 4 green boxes and 7/8 satellites showing.
Many thanks.
Chris

Pages: [1]