2
« on: July 30, 2019, 11:04:16 am »
So, after several successful flights through France with no issues I yet again start to get issues with PAW.
No change to my kit or set up...Samsung Tab 3 8.0 (T315)running SkyDemon and powered by Anker PowerCore 20100 with genuine cable.
The tablet lost connection with the PAW just after climb out. Rather than mess around, I went to the tablet location services and used the built in GPS and continued enroute.
On landing I checked for:-
wifi connection to the PAW...All Ok.
Config web pages...Unable to connect
GPS dongle in situ and flashing... All Okay
There were some Green lights working on the board but couldn't ascertain which ones with the cover still on. (Think i'll drill some holes in the top so I can see them)
It's almost as if the software froze....but why should it if it has run successfully on previous trips?
The unit had been sitting on the coaming throughout the flight and following a reboot I accessed the config pages and noted that the temperature was 78.3 degrees...( hot but not excessive I thought)
Is there anything I can do to assist in the fault finding process as I love the unit when it works but I'm getting pretty disillusioned with the reliability at the moment?