Topics

1

General Discussion / Aircrew flight instrument

« on: February 09, 2024, 12:12:25 pm »

Does anyone have an aircrew.co.uk flight instrument no longer being used they wish to sell?

2

General Discussion / Igrid phone

« on: July 12, 2023, 11:20:52 am »

Does anyone use the Samsung z fold 3 as their igrid hotspot? And results please

3

General Discussion / fitment of wired in aerials.

« on: April 18, 2021, 07:11:59 pm »

I have fitted the Rosette to my Xair panel and used the wired aerials one each site of the cockpit 6 inches from the door tubes and half way up the screen. The Rosette is tucked behind the Samsung Tab 2s mount. The problem I have is that PAW loads up and locks onto skydemon but then immediately drops off saying gps lost. Even if I reload the same thing happens. I am powering using an anker usb socket into the mains power mount. Going over to locations services everything works fine so I assuming the tablet gps is working ok. I have also attached to the Rosette the aircrew instrument which shows that wifi is active. Any clues would be appreciated.

4

General Discussion / Error connection with paw wifi

« on: November 04, 2020, 05:43:49 pm »

If I open skydemon on my home wifi and close when I open in the plane it logs onto paw wifi. If I don't do this skydemon will not connect to paw showing connection error. No problem with easyvfr. Anyone had the same problem.  Using a Samsung tab 2s.

5

Technical Support / using extension cables

« on: May 25, 2017, 04:07:32 pm »

Has anyone used extension cables for the existing P3i aerial from the classic box and used within the aircraft. Likewise for the gps dongle. I have no room on the panel top for the unit to sit on and considering placing the P3i aerial on the side on the screen using a suction cup and like wise with the GPS dongle and then stowing the unit box. Any thoughts anyone?

6

Technical Support / Runwayhd

« on: May 17, 2017, 08:01:52 pm »

I am a newbie to this techno PAW so maybe I am doing the right thing but the wrong way. I have recently (today) received my PAW. I have set up as per the quick start and everything appeared to be going well. The PAW is powered by a 22400mah ec technology type 2 charger bank with the 3 outlets. I used the ipad giving 2.4a output. The PAW powered up and all the lights appeared as per the instructions. Followed the details to get the wifi hotspot with no trouble. The config page with the details on showed all the greens in the 5 boxes. Now it came to connecting my Samsung note 2 and note 4 along with the Lenovo 7 inch tab to the PAW following the instructions in the manual. None of them showed the flarm icon in the settings so I could proceed no further. My gps test showed 15 sats so that should not have been a problem and the config page as I recall had inputs showing which I assume should it was working. Now at a loss to think what it could be stopping the downloading. Anyone had similar problems to solve this please. Regarding the battery for another go ..