Messages

1

Technical Support / Re: software update

« on: April 03, 2018, 10:18:53 pm »

You are spot on. The file had been named with update (4) .png. After renaming the file it installed without any issue, I will look out for this next time.

Thank you so much.

Regards
Erol.

2

Technical Support / software update

« on: April 02, 2018, 07:41:12 pm »

Hi all,

I have just updated my license key, all is working well and the unit is showing the new renewal date. I have just tried to update to the latest 2018 software but keep getting the message /root/servers/check.sh: error cannot access update details.

I have updated the software before in the same manner without any problems. I'm using the same (GPS) usb port and the memory stick is fine. My present installed version is 20170721.

Any ideas out there.

3

Technical Support / Re: ADS-B out and Trig TT21

« on: November 23, 2017, 08:37:58 pm »

Hi Chaps,

As advised, I have configured USB port 1 to Trig transponder and set Baud rate to 9600, everything is now working great.
A big thank you for everyones input on this, much appreciated.

Erol.

4

Technical Support / Re: ADS-B out and Trig TT21

« on: November 22, 2017, 11:51:43 pm »

Hi,

No I didn't set the USB port up, I will try this next, I wasn't aware I had to do this.
My Baud rate is set to 4800, so will change this also. Do you change the GPS certification level in the pilotaware configure screen, as well as setting the type on the trig unit?

This info is really helpful, thank you very much for such a fast response.
I will let you know how it goes.

5

Technical Support / ADS-B out and Trig TT21

« on: November 22, 2017, 07:27:54 pm »

Hi all.

Can anyone offer advice with wiring the Farnell usb cable to the Trig 21. My transponder came with a pre-wired loom and the GPS input cable is labelled. I have connected this cable to the farnell usb orange wire and the black wire to aircraft ground. I have also connected the screen around the trig gps input cable to ground also.
The Farnell usb connector lights up when power is connected but I am not getting any gps data to the trig unit.

It has the latest software.
I have set the gps input to NMEA 0183.
However, I can't see where to change the data settings SIL or SDA as these are not in the set up menu.

Any advise would be appreciated.