Messages

1

Technical Support / Re: Dead unit ?

« on: April 16, 2017, 09:20:52 am »

Morning,

So, Ive configured another SD card, its all loaded, checked settings and traffic data present 

All set to go...

Thanks for your help chaps !!!

Stuart

2

Technical Support / Re: Dead unit ?

« on: April 16, 2017, 12:43:05 am »

Hi Peter

So, the card supplied with the PilotAware will not format, it fails every time, so it must be corrupt...
I have another card from my GoPro, I will try that card although it is a larger capacity.
Format of that card has been successful, and I have transferred the software over.
It is now loading, on the TV, I can see it now...

Will advise, but its looking good so far.... tempting fate 

Stuart

3

Technical Support / Re: Dead unit ?

« on: April 15, 2017, 11:43:22 pm »

Sorry, no rainbow... My TV has message "No Signal"

I will try to reload the image file, if that's the next step ...

Many thanks,
Stuart

4

Technical Support / Re: Dead unit ?

« on: April 15, 2017, 11:27:26 pm »

Nothing when plugged into the HDMI

5

Technical Support / Re: Dead unit ?

« on: April 15, 2017, 11:25:42 pm »

Hi Peter,
yes the LED's are both steady, I have also tried my iPad charging Plug socket too, but no difference.

Will try the HDMI ...

Stuart

6

Technical Support / Re: Dead unit ?

« on: April 15, 2017, 11:20:01 pm »

Hi Lee,

I have checked the card, and just rechecked it incase, but its in correctly ...
Using a Morphie power block to power it up this evening.

Stuart

7

Technical Support / Dead unit ?

« on: April 15, 2017, 10:23:44 pm »

Hi Guy's

I have to admit to not using my PilotAware as much I thought I would ... but typically, sods law, I want to use it tomorrow and I went to check it out and it does not respond ?
When powered up the red & green LEDs illuminate, the GPS receiver LED will flash once briefly when the power cord is pushed in. It doesn't appear to have any WIFI link, No Enet link - I think that's because the port is not powered ? and there is no further indication the GPS receiver is powered ?

Is there any factory reset or other thoughts ?

Many thanks

Stuart