Messages

1

Technical Support / Re: ADS-B doesnt work

« on: December 25, 2017, 02:48:59 pm »

Ok I will arrange to purchase one from the shop.

2

Technical Support / ADS-B doesnt work

« on: December 25, 2017, 12:26:26 pm »

Hello all,

I've assembled my PAW using a Raspberry Pi.  It is complete except I haven't installed a bridge.

I've no luck getting the ADS-B dongle to work as shown below.

Any suggestions?


PilotAware Version(20170721) License Expires(20181224)


_   ________Interface________   ______________________Status______________________
   HOSTID   B
   PLATFORM   Model B+, kernel=4.9.35+
   DATE   Fri Jul 21 17:07:36 2017
   ETH0-IP/GW   / 0.0.0.0
   WLAN0-IP   192.168.1.1
   UPTIME   17:07:36 up 0 days 00:19, Load 0.71:0.55:0.55, cpu_temp=37.9'C
   CLIENTS   Connected WiFi=2 TCP=0
   ADS-B (DVB-T)   Unavailable Msgs=0(+0)
   TRX (RXTX)   Unavailable TX=0 RX=0 CRCFAIL=0
   Pressure Altitude (BMP)   Unavailable (Manual) QNH=1013mb QNE=0ft GNSS=0ft
   GPS   USB Msgs=6980(+42) Fix="Invalid" Mode="Not Available" Satellites=0
   USB 0411:01a2   Ralink 802.11 n WLAN
   USB 1546:01a7   u-blox AG - www.u-blox.com u-blox 7 - GPS/GNSS Receiver
   USB 1d6b:0002   Linux 4.9.35+ dwc_otg_hcd DWC OTG Controller