1
Technical Support / Re: connecting Trig TT21 to PilotAware
« on: June 15, 2016, 07:10:45 am »
Hi
sorted many thanks
Mark
sorted many thanks
Mark
Show Posts
You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.
Pages: [1]
2
Technical Support / Re: connecting Trig TT21 to PilotAware
« on: June 14, 2016, 10:56:13 pm »
Hi
I understand that and have the following ordered from Farnell ( well I hope I do )
USB-RS232-WE-1800-BT-0.0 CABLE, USB A - RS232, SERIAL CONVERTOR
part number
USB-RS232-WE-1800-BT-0.0
this will give me four wires
power -not required
ground - required connection to trig ground
which of the other do I need to connect to for the GPS in wire from the trig unit ?
Data +
or
Data -
Mark
I understand that and have the following ordered from Farnell ( well I hope I do )
USB-RS232-WE-1800-BT-0.0 CABLE, USB A - RS232, SERIAL CONVERTOR
part number
USB-RS232-WE-1800-BT-0.0
this will give me four wires
power -not required
ground - required connection to trig ground
which of the other do I need to connect to for the GPS in wire from the trig unit ?
Data +
or
Data -
Mark
3
Technical Support / Re: connecting Trig TT21 to PilotAware
« on: June 14, 2016, 08:35:39 pm »
fair comment it would help to be sure
I just need help on which pin to use on the usb is it D+ or the D- along with the ground ?
mark
I just need help on which pin to use on the usb is it D+ or the D- along with the ground ?
mark
4
Technical Support / connecting Trig TT21 to PilotAware
« on: June 14, 2016, 03:50:16 pm »
Can anyone help with the connecting of PilotAware with the trig transponder with up to date firmware installed
I have the two wires from the Trig unit( GPS position in and ground) where do they connect on the raspberry pi ?
Mark
I have the two wires from the Trig unit( GPS position in and ground) where do they connect on the raspberry pi ?
Mark
Pages: [1]