Show Posts
1
General Discussion / Re: First Time Booting
« on: November 10, 2015, 09:14:12 am »
Lee,
first of all may I thank you for producing an excellent product; hopefully it will provide another tool for pilots to fly safe.
Yesterday I received all the bits (less GPS dongle) to set up my pilotaware system. This I have done as described in the manual, however my initial boot up does not seem to work; i.e I don't get any final message to say the installation is complete. To check it wasn't the Pi I just loaded NOOBS and it worked fine. Having reloaded PilotAware, at the moment it gets to a certain point showing all the script and then I just get the message 'Licence Fail for eth0 xx:xx:xx:xx and Licence Fail for wlan0 xx:xx:xx:xx' (where xx:xx:xx:xx is a MAC address) scrolling up the screen.
Any suggestions as to what the problem might be. I have tried searching the other postings but can't seem to find an solution.
Many thanks
Bob
first of all may I thank you for producing an excellent product; hopefully it will provide another tool for pilots to fly safe.
Yesterday I received all the bits (less GPS dongle) to set up my pilotaware system. This I have done as described in the manual, however my initial boot up does not seem to work; i.e I don't get any final message to say the installation is complete. To check it wasn't the Pi I just loaded NOOBS and it worked fine. Having reloaded PilotAware, at the moment it gets to a certain point showing all the script and then I just get the message 'Licence Fail for eth0 xx:xx:xx:xx and Licence Fail for wlan0 xx:xx:xx:xx' (where xx:xx:xx:xx is a MAC address) scrolling up the screen.
Any suggestions as to what the problem might be. I have tried searching the other postings but can't seem to find an solution.
Many thanks
Bob