Messages

1

Technical Support / Re: Wifi connection does not appear

« on: September 29, 2020, 09:30:28 pm »

It behaves exactly the same whether in or out of the aircraft.  This evening I had to connect and disconnect the battery about 6 times before the Pilotaware network appeared.  I attach the home and config pages as you requested.  On the network page I tried increasing the power to 100mW and changing the channel but it made no difference.

2

Technical Support / Wifi connection does not appear

« on: September 29, 2020, 04:01:36 pm »

I have recently upgraded without problem to the new software.  However, I have suffered from a slightly strange problem for a considerable time pre-dating the update.  Whenever I switch Pilotaware on (I am using Rosetta powered by the recommended Anker battery in my plane) the Pilotaware network never appears in my list of available networks until after I have plugged and unplugged the battery two or three times.  It is annoying that it never works first time, but when it does connect, it seems to work fine.  I have checked the lights for signs of trouble, but it is always solid red and flashing green so no obvious problem.  I did notice in flight the other day that the Baro was red which the manual says is very unusual, but it was green again when back on the ground.  Any ideas to resolve this?