Messages

1

Technical Support / Re: Rosetta help needed

« on: May 28, 2018, 09:23:47 pm »

Managed to fly on Saturday. All locked on and worked as advertised.  Unfortunately not a lot of others flying so didn’t get any real alerts, but could see the airliners. Even the ground loop isolator seems to have cured the headset problem too.
Obviously all operator error.
Thanks for all the help
Cheers

Steve

2

Technical Support / Re: Rosetta help needed

« on: May 22, 2018, 02:25:57 pm »

Great. That worked thank you. I can now see the aircraft. I will try it in flight next time I go to the plane. I’ll also try and get a ground loop isolator for the audio and try that.

Thanks for the help
Cheers
Steve

3

Technical Support / Re: Rosetta help needed

« on: May 22, 2018, 01:19:50 pm »

Ok here I hope are the screenshots. When I bought it, one of your guys kindly did the setup for me.
Regarding SD, I was expecting to see symbols of aircraft and only expecting audio through the headset via the cable from PAW
Thanks guys

4

Technical Support / Rosetta help needed

« on: May 22, 2018, 09:48:12 am »

Hi
I bought a Rosetta at Popham and now have the relevant Anker power pack. I have tried it once in the plane and have a couple of problems. If I connect in the garden, it all works except I cannot see the traffic on Skydemon. I can see it (the airliners mainly) on the radar. I have PAW slected in SD and when I set to 'go flying' I select PAW. It immedialey gives me my position as usual but no traffic (this is the same on iphone). I have the vertical limits in SD set to 45,000. I'm sure it is something as simple as a setting I have wrong.
Also on a different note, when I have it in the plane and had the audio cable connected to the headset (Bose A20), I had bad background noise constantly and really bad static when transmitting. I thought initially this was the power adaptor (before I got the power pack) that I was using (Anker again) as I had this problem before with different adaptors for charging Ipad, but this adapator has been ok. When I disconnected the audio cable all was well again. Also I could hear the traffic warnings but no traffic on SD.
Any help please
Thanks
Steve