Messages

1

Technical Support / Re: Incorrect Date on PAW

« on: February 11, 2018, 02:46:15 pm »

Thanks Peter for the suggested actions.
However, I still get the same "No software Updates Available" after following exactly the procedure defined.

I have managed to get the date to be correct now by leaving the PAW outside for a while so I assume the GPS updated the time when it go a fix on the satellites.

When I press "Check for Updates" I get a short wait before a message pops up then disappears and goes back to the  "No software Updates Available"
The message is:
"Checking for updates
/root/servers/check.sh: Error, Cannot access update details"

Any further suggestions would be greatly appreciated......

Regards
Marcus

2

Technical Support / Re: Incorrect Date on PAW

« on: February 10, 2018, 10:19:40 pm »

Thanks Peter,
I have tried to load the https://www.pilotaware.lode.co.uk page but all I get is:
This site can’t be reached
I have tried it on 3 different devices but cannot access it from any of them.

The Pilotaware had been plugged in for several hours now but there is no update available under "updates".

Any ideas on what I can do to get the updates loaded to the Pilotaware?

Thanks
Marcus

3

Technical Support / Incorrect Date on PAW

« on: February 10, 2018, 08:25:42 pm »

Hi,
Can anyone help with a problem with the date on "Home" page being incorrect?
I have updated my license key successfully after a period of non-use, but the Pilotaware version is still (20161124) despite plugging it into my Broadband ethernet port of several hours.
Also the date is showing as Wed Aug 2 2017.

I have been through the instructions and forums and cannot find this problem.
Any help would be much appreciated

Marcus