PilotAware

British Forum => General Discussion => Topic started by: ChrisBell on September 28, 2015, 02:32:57 pm

Title: Voltage check
Post by: ChrisBell on September 28, 2015, 02:32:57 pm

Getting ready to turn mine one.

Noticed when I started soldering there was a notice warning people to check the V out put.

does that still need doing ? if so over what pins ?

Best,

Chris

Title: Re: Voltage check
Post by: Admin on September 28, 2015, 02:51:22 pm

I would test that only 3.3v is going to the ARF.
If you supply 5v then the amplifier is destroyed, so always good to check before plugging in.

Title: Re: Voltage check
Post by: ChrisBell on September 28, 2015, 05:28:17 pm

Ok thats great - any idea what pins I should be checking ?

Title: Re: Voltage check
Post by: Admin on September 28, 2015, 06:45:42 pm

If you are using the digole reg, I recall as you look at the top of the digole, top left is PWR, bottom left is GND