Messages

1

Technical Support / Rosetta stopped working

« on: August 09, 2021, 04:55:14 pm »

My Rosetta stopped transmitting the WiFi signal and I can’t get contact with it again.
 
I checked the SD card and it appears to be defective as I can’t format it  - so I took another SD card and formatted this and copied the latest software onto the card as per instructions on your site.
 
Still I am not able to get contact with the Rosetta and I connected it to HDMI to see what happens.  Please see images attached for what it writes during boot sequence.

Any ideas ?

2

General Discussion / Re: Serial Output

« on: October 06, 2016, 09:08:56 am »

Excellent - That is kind of what I expected.  As long as you know there is someone close - keep a look out.

3

General Discussion / Re: Serial Output

« on: October 05, 2016, 10:48:23 am »

Sounds Fantastic.

My EFIS is Advanced Flight systems - Advanced Deck 5600.  It is supposed to have an interface box for ADSB-In (since it's a US product this would be for weather, traffic, Pilot info), but as far as I can tell, it's connected to the Display Units through a normal RS-232 serial interface.  Probably 9600.  I can check it later.

For Europe, I would only receive traffic information, and if your system provides also Mode C/S + and even FLARM (if a Flarm mouse is connected) then it's only added value.

Quick questions:
Can I install antennas on the outside of the aircraft ?  Should the receiver be on upper or lower fuselage ?  What is best ?
For non-ADSB aircraft - I suppose you can only provide basic information such as there is received a signal?  It would not be direction/altitude etc right ?

Thanks
Per
Copenhagen, Denmark