Show Posts
1
Technical Support / No C/S traffic plus iPad runs v slowly
« on: September 21, 2017, 01:22:27 pm »
I have re-commissioned my PilotAware with the new software key. But have two problems (plus one other question):
1. I use Runway HD running on an iPad mini 2. It is displaying airline type traffic but I cannot see any mode C or S traffic. Nor can I see any glider/FLARM traffic. I know there has been plenty of both during the 3.5 hours of test flying I've done in the past week. This is with the filters set wide open. Any idea what the problem is? How should ModeC/S traffic be shown in Runway HD?
2. The iPad slows right down after about 15 minutes, for example, taking approx 60 seconds to "catch up" with true heading and position. If Pilot Aware is switched off and on again, the iPad operates normally again at first, before progressively slowing down again. Is this something to do with logging? What can I do about it?
3. A question: Am I right in thinking that Pilot Aware's "radar" display does not require Runway HD to be running (i.e. could work stand alone, with the iPad's only function being to display the output)?
1. I use Runway HD running on an iPad mini 2. It is displaying airline type traffic but I cannot see any mode C or S traffic. Nor can I see any glider/FLARM traffic. I know there has been plenty of both during the 3.5 hours of test flying I've done in the past week. This is with the filters set wide open. Any idea what the problem is? How should ModeC/S traffic be shown in Runway HD?
2. The iPad slows right down after about 15 minutes, for example, taking approx 60 seconds to "catch up" with true heading and position. If Pilot Aware is switched off and on again, the iPad operates normally again at first, before progressively slowing down again. Is this something to do with logging? What can I do about it?
3. A question: Am I right in thinking that Pilot Aware's "radar" display does not require Runway HD to be running (i.e. could work stand alone, with the iPad's only function being to display the output)?