1
General Discussion / Group id and flight ID in P3I
« on: June 07, 2020, 04:12:18 pm »
Hi,
I was just wondering what I'm missing! ? with both Group ID and Flight ID not being transmitted according to the P3I spec i was wondering what the point of these are and also how the function of group ID as described is achieved give they are not transmitted?
Have I missed where in the protocol they are added or something else?
Group ID
Associate yourself with a group of aircraft on a fly out or a club event by associating
yourself with a Group ID. All aircraft in the same group as you will be bracketed with the ‘#’
character, so will appear as #Group-ID#. This is set to PAW-Group by default so you can
determine PAW traffic from ADSB in the first instant. It is fully acceptable to leave this
blank.
Flight ID
Normally your Reg
P3I spec
http://www.pilotaware.com/wp-content/uploads/2017/03/Protocol.pdf
I was just wondering what I'm missing! ? with both Group ID and Flight ID not being transmitted according to the P3I spec i was wondering what the point of these are and also how the function of group ID as described is achieved give they are not transmitted?
Have I missed where in the protocol they are added or something else?
Group ID
Associate yourself with a group of aircraft on a fly out or a club event by associating
yourself with a Group ID. All aircraft in the same group as you will be bracketed with the ‘#’
character, so will appear as #Group-ID#. This is set to PAW-Group by default so you can
determine PAW traffic from ADSB in the first instant. It is fully acceptable to leave this
blank.
Flight ID
Normally your Reg
P3I spec
http://www.pilotaware.com/wp-content/uploads/2017/03/Protocol.pdf