1
Technical Support / Re: Rosetta to trigTT2Q
« on: May 22, 2019, 09:44:21 am »
Checked all again and changed port 4 name to trig, had a flight and it’s all working
Thanks everyone
Regards
Jeff
Thanks everyone
Regards
Jeff
Show Posts
You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.
Pages: [1]
2
Technical Support / Re: Rosetta to trigTT2Q
« on: May 21, 2019, 10:25:36 pm »
I will have a check of settings tomorrow,
Thanks everyone.
I will report back
Regards
Jeff
Thanks everyone.
I will report back
Regards
Jeff
3
Technical Support / Re: Rosetta to trigTT2Q
« on: May 20, 2019, 10:18:33 pm »
Hi Pete,
Pretty sure I have them the same rate. I spoke to Ashley who said it didn’t matter what you called them so they are set to auto.
I will check the baud rate on both units again.
Regards
Jeff
Pretty sure I have them the same rate. I spoke to Ashley who said it didn’t matter what you called them so they are set to auto.
I will check the baud rate on both units again.
Regards
Jeff
4
Technical Support / Rosetta to trigTT2Q
« on: May 20, 2019, 08:02:42 pm »
I have just upgraded from a standard pilot aware to a Rosetta, however the trig now has no info to give me my adsb, the usb lights up and the baud rates are correct I think. Any ideas
Pages: [1]