Messages

1

General Discussion / Re: Compatible with iGlide or iPilot navigational software

« on: July 27, 2018, 03:57:08 pm »

Now I bought the Rosetta box. It works good with Air Navigation Pro, but unfortunately not with my preferred app: iGlide. The GPS data and altitude is displyed correctly, but there is no traffic (ADS-B). I couldńt test the Flarm yet.

Any idea, what the problem could be? IGlide is able to display Flarm and ADS-B traffic according to the manufacturer and as for flarm, I can confirm it.

My aim was to integrate the ADS-B traffic in iGlide. Can I provide you with more data, logs or whatever?

And thanks for the very fast delivery - even to Germany!!!

2

General Discussion / Re: Compatible with iGlide or iPilot navigational software

« on: July 22, 2018, 09:11:30 am »

I tried it yesterday, but the traffic is not displayed, even altitude is zero all the time. Is this because of the missing bridge? GPS data is transfered to the iGlide via WiFi an the PAW is recognized as a Flarm device.
Conected to air navigation pro, it shows traffic, GPS and altitude.
But I want or have to use iGlide...
Any idea?
Are your bridges available?

3

General Discussion / Re: Compatible with iGlide or iPilot navigational software

« on: July 04, 2018, 11:38:58 pm »

I can check it by myself, because I have already a license of iGlide. Can I test the functionality without a pilot aware license and without the bridge? I already a raspi 3B (no plus) with an ublox8 GPS receiver and a DVB-T ADS-B receiver (looks like the one you offer). Version 20180520 is installed. but the five interface status bars are red (192.168.1.1). That´s probably because there´s no license installed? But I can´t get a license without the bridge board, right? My MAC-address is: B827EB811B00 (raspi WiFi). Perhaps you have a demo license for a short time to test it?

4

General Discussion / Compatible with iGlide or iPilot navigational software

« on: June 30, 2018, 07:16:17 am »

I used to work with iGlide, a navigational software by air avionics that runs on my iPad mini. It connects to airconnect via WiFi. In my understanding Rosetta or classic PAW uses the same protocol as airconnect - at least that‘s the interface type which is chosen in other software. So I guess, it should be compatible to iGlide, iPilot or FreeFlight (https://www.air-avionics.com/?page_id=439).

Has anybody this combination and can confirm that it works?

Thanks!