1
Technical Support / FTDI cable
« on: May 13, 2017, 03:36:01 pm »
I have connected my Trig TT21 transponder to the preferred USB-RS232 cable and had no problem with location data being displayed previously.
Since then I have updated the software on the PA, and added the bridge, and now have no data at the transponder.
As part of the fault finding process can someone tell me if the LEDs in the USB FTDI cable flash normally in use ?
I have tried outputting data from a PC to the cable and the red led flashes, showing data transmission, but nothing, apart from the initial boot-up on the PA....
The Home screen shows the FTDI cable ok..
cheers
Since then I have updated the software on the PA, and added the bridge, and now have no data at the transponder.
As part of the fault finding process can someone tell me if the LEDs in the USB FTDI cable flash normally in use ?
I have tried outputting data from a PC to the cable and the red led flashes, showing data transmission, but nothing, apart from the initial boot-up on the PA....
The Home screen shows the FTDI cable ok..
cheers