Messages

1

Technical Support / Re: Installing 20190621 - SDFormat and Software upgrade

« on: July 07, 2019, 12:53:41 pm »

I already have a Rosetta. I decided to upgrade to the new software and followed all the instructions. I used the 8gb SD card that was already with the Rosetta. With the HDMI cable plugged in I got message on screen saying writing boot files to memory I went too be, got up in the morning and the same message on screen. I tried again, leaving it for an hour with the same result. I tried a 16gb card and this worked. It looks to me like the new software is close to filling a 8gb disk that unless the formatting tool gives you the full 8gb you will have problems. When I formatted the disk I got about 7.65 gb.

So in short, if you are struggling to get the new software to install try a 16gb card.