Messages

1

Technical Support / Re: UPDATE INSTALLED

« on: January 03, 2022, 04:11:12 pm »

Many thanks both your solutions have solved both problems on both iPads and the aircraft is now showing again on the ground station.

2

Technical Support / UPDATE INSTALLED

« on: January 03, 2022, 03:38:55 pm »

I’ve updated my Rosetta using the Pilotaware app and since the update my Strip and OGN station are at my house and I used to be able to pick up my aircraft on my own ground station and and check its working when in the garden but since having installed the update the ground station no longer picks up my Aircraft, i’ve checked the hex code and it is correct and when is connected to SkyDemon and the groundstation is showing on the map and other aircraft going overhead, also with two iPads connected to the Rosetter next to each other when logging into the settings one iPad will not go to the homepage but connects to the radar and other pages okay, the other iPad will go to the homepage and all of the pages except the radar page where it says network error, any ideas what may be the problem thanks.

3

OGN-R PilotAware / Re: PWEverton

« on: July 18, 2021, 02:43:23 pm »

This may help https://ognrange.glidernet.org/?#PWEverton,max,lastweek,52.08782_-0.21426,10.17189948661882,#000000ff:#000000ff,circles;

4

OGN-R PilotAware / Re: Feeding 360Radar

« on: September 28, 2020, 11:36:12 pm »

Thanks I will contact Keith

5

OGN-R PilotAware / Re: Feeding 360Radar

« on: September 28, 2020, 03:43:12 pm »

PWNorton

6

OGN-R PilotAware / Feeding 360Radar

« on: September 28, 2020, 12:17:33 pm »

We have a fully updated Pilotaware OGN running , to feed 360Radar is it as simple as putting up a 1090 antenna plugging that into a Sdr dongle and then plugging that into the Raspberry pie unit and then requesting to be unlocked

Many Thanks

7

OGN-R PilotAware / Re: Register own Rosetta on OGN devices database

« on: September 15, 2019, 08:55:09 pm »

Leave competition number blank

Aircraft reg as.  G- then your reg assuming G registered

Aircraft type scroll down and click on your aircraft type

Device ID put your hex code

Device type   I put OGN and working ok not sure about the others

Tick the small boxes if you don’t want to be tracked and do tick the box to confirm you are the owner

8

Technical Support / Re: Software Update 20180129

« on: February 08, 2018, 01:35:20 pm »

Hi Lee

Tried again as per instructions but still the same screen comes up.
2 screen shots as requested

Thanks

9

Technical Support / Re: Software Update 20180129

« on: February 08, 2018, 12:09:52 am »

I’m trying to update using Ethernet cable as I did for the July update but when I click check update for the install I keep getting the attached screen come up , anyone have have an idea why

Many Thanks