1
General Discussion / Re: voice alert headset adaptor 3.5mm for your pilotAware
« on: November 16, 2016, 03:09:41 pm »
I use David Clark
Show Posts
You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.
Pages: [1]
2
General Discussion / Re: voice alert headset adaptor 3.5mm for your pilotAware
« on: November 15, 2016, 07:10:21 pm »
Hi Keith ,
I got one and it works well. There is no block as such but works well.
I got one and it works well. There is no block as such but works well.
3
General Discussion / voice alert headset adaptor 3.5mm for your pilotAware
« on: November 15, 2016, 12:13:25 pm »
Hi All ,
If anyone is interested in purchasing standard GA headset adaptor for your pilotAware kit for Voice Alerts. This is available of ebay under this link below
http://www.ebay.co.uk/itm/Aviation-Headset-Adaptor-3-5mm-Male-MP3-Pilot-Aware-to-GA-Headset-/112205150917?hash=item1a1ff2bac5:g:yAwAAOSw5cNYKt0S
If anyone is interested in purchasing standard GA headset adaptor for your pilotAware kit for Voice Alerts. This is available of ebay under this link below
http://www.ebay.co.uk/itm/Aviation-Headset-Adaptor-3-5mm-Male-MP3-Pilot-Aware-to-GA-Headset-/112205150917?hash=item1a1ff2bac5:g:yAwAAOSw5cNYKt0S
4
Technical Support / VOICE ALERT AND Mode C/S ONLY SUPPORTED ON RASBERRY PI 2 MODEL B
« on: October 26, 2016, 11:17:28 am »
Hello everyone , just to share an experience with building my own PilotAware. I ordered a pi 2 model B but was sent a model B+ which i did not notice, until email comms with Keith who mentioned about B+ not configured to work with the pilot aware bridge and software and will not offer voice alert or Mode C/S .
So if you are planning on building one , make sure to use pi 2 model B which is also sold as pi 2 model B version 1.1
The volume feature and zone settings will appear once you enter your licence key and save it.
For any reason if you change rasberry pi board then you have to obtain a new licence key by emailing support@pilotaware.com by sending your HOSTID which is displayed on your home page of your pilot aware interface on 192.168.1.1 via your device browser while connected to pilot aware wifi network.
So if you are planning on building one , make sure to use pi 2 model B which is also sold as pi 2 model B version 1.1
The volume feature and zone settings will appear once you enter your licence key and save it.
For any reason if you change rasberry pi board then you have to obtain a new licence key by emailing support@pilotaware.com by sending your HOSTID which is displayed on your home page of your pilot aware interface on 192.168.1.1 via your device browser while connected to pilot aware wifi network.
Pages: [1]