Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.


Messages - Bulleteer

Pages: [1]
1
Lee,

Thanks, as always, you feedback is swift and most welcome. I will connect the Tip on my TRS connector to my Audio in on the Dittel and the sleeve and the sleeve to earth.

Many thanks,

Mark

2
Technical Support / PAW to Dittel KRT2 Radio wiring (PAW audio out)
« on: July 13, 2017, 01:48:56 pm »
I want to wire my new PAW audio output to my Dittel radio. I know that the Audio in should be wired to pin 5 on the Dittel plug, however, I am not sure which wire to use from my 3.5mm plug lead that goes into the PAW. My wiring on the Audio lead is as follows;

1. White wire - Tip
2. Red wire. - 1st ring near Tip
3. Earth Wire - Sleeve

Do I connect the Tip or the Ring wire to the Audio in on the Dittel (pin 5)?  Also, does the earth wire need to be terminated on the Dittel or just to an earth on the aircraft?

Thanks in advance for your help.

Regards,

Mark

3
Technical Support / Re: Tuned Low Profie Antenna
« on: July 08, 2017, 08:35:41 pm »
Thanks Peter, much appreciated.
Mark

4
Technical Support / Re: Tuned Low Profie Antenna
« on: July 07, 2017, 06:14:26 pm »
I have seen these mounted horizontally on the top of the aircraft dash panel, so just to confirm, you reckon they should be vertically installed as per second pic, not first?

5
Technical Support / Tuned Low Profie Antenna
« on: July 07, 2017, 10:21:04 am »
Should the tuned low profile antenna be located horizontally or vertically?

6
Technical Support / Re: Audio Out Jack - 3.5mm
« on: June 30, 2017, 10:05:04 am »
Thanks Peter, just got my PA and wan to hook it up to my Dittel KRT2 radio. The other post will help with this as well. Much appreciated.

Mark

7
Technical Support / Audio Out Jack - 3.5mm
« on: June 29, 2017, 07:44:47 pm »
Is the audio out jack on the Pilot Aware a stereo or mono socket?

Pages: [1]