Messages

1

General Discussion / Re: Air nav pro flarm not connecting

« on: November 21, 2015, 11:45:31 pm »

It finds heavys at 33,000 ft at 400 knots, but can't locate a c150 in circuit! Not seeing transponders!
What should I do next?

Thanks for your time Lee

Neil.

2

General Discussion / Re: Air nav pro flarm not connecting

« on: November 15, 2015, 11:58:40 pm »

That did it it just tracked traffic out of Eastmidland!

Thanks lee

Neil

3

General Discussion / Re: Air nav pro flarm not connecting

« on: November 15, 2015, 11:09:25 pm »

Hi Lee
Air nav pro and collision aware  on a iPad mini retina, PAW release 20151107 loaded onto the pi
Flarms set as per instructions
Pin: 6001
IP address:192.168.1.1
Port:2000
The sensor button turns orange briefly then turns back to red.
Air nav pro firmware: 5.8.2
Is this ok ?

4

General Discussion / Air nav pro flarm not connecting

« on: November 15, 2015, 08:48:18 am »

I am unable to get flarm to work on my iPad after connecting ?

5

General Discussion / Re: ARF Shield - Digole 5v-3.3v regulator board

« on: September 15, 2015, 08:47:40 pm »

hi Lee

Need to check with you about the regulator?
I've ordered the following: xbee/pro/ciseco XRF breakout board to 0.1" DIP adaptor 3 LED indicator.
Is this correct ?
Best regards
Neil

6

General Discussion / Re: ARF Shield - Digole 5v-3.3v regulator board

« on: September 15, 2015, 08:24:20 pm »

Thanks for this thread as I couldn't track this regulator down either, now just have to wait to complete assembly 😎