Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.


Messages - AdrianK

Pages: [1]
1
Technical Support / Re: GPS issue
« on: June 05, 2021, 11:08:13 am »
What address should I use to send them to Lee?

2
Technical Support / Re: GPS issue
« on: June 05, 2021, 11:06:34 am »
Try again!

3
Technical Support / Re: GPS issue
« on: June 05, 2021, 11:04:32 am »
Thanks again Peter.....my final question (I hope!

4
Technical Support / Re: GPS issue
« on: June 04, 2021, 09:37:03 pm »
I guess not as the file size would be too large?

5
Technical Support / Re: GPS issue
« on: June 04, 2021, 09:14:08 pm »
Is it possible to post the track files from an iPad?

6
Technical Support / Re: GPS issue
« on: June 04, 2021, 08:51:21 pm »
Many thanks Peter!

7
Technical Support / Re: GPS issue
« on: June 04, 2021, 06:50:16 pm »
Please could you give me a steer as to where to find the ‘flight file’? Thanks.

8
Technical Support / Re: GPS issue
« on: May 30, 2021, 02:43:28 pm »
P.S The power supply unit is a Charge2.....

9
Technical Support / GPS issue
« on: May 30, 2021, 08:40:09 am »
Hi All,
We have been successfully running a Rosetta for a couple of years but yesterday encountered a problem with loss of GPS signal in flight to two independent iPad minis. Booted up ok on the ground. We’re using an ‘approved’ hard-wired power supply (iCharge I think) and the unit itself sits under glass at the back of the cockpit with a clear view of the sky but we don’t use a GPS mouse. Once the signal was lost it could be regained by ‘Stop Navigating-Go Flying-reselect PaW as location source’ but after a few minutes the GPS was lost again. Checked the power supply connections with nothing obviously loose. Any suggestions as to how to troubleshoot this? The only recent change to the system was entering a new licence key. Up to now the system has worked very well and even better after fitting external aerials. Thanks, Adrian

10
I’m struggling to get the 20190621 update to load onto our Rosetta. This is using brand new recommended SD cards and the recommended formatter program. Download seems ok....likewise upload to SD card seems ok but the software doesn’t ‘unpack’ onto the Rosetta (even after 30 minutes). Reinserting the old OE SD card restores the Rosetta to a functioning unit (after about 10 mins) . Looking at the properties of the new card is shows as FAT32 and (compared with the OE card) all the files look as though they’re present. Any ideas?

Pages: [1]