Hi Eric,
Are you following the set-up instructions from the PAW document entitled “Building and Installing an OGN-PilotAware Uplink to detect and retransmit glider locations” ? If so, it says “ Connect on the same network as the Pi to
https://ognpaw.local:4200/“, so what you have written is incorrect.
I found it easier to just connect a keyboard and monitor directly to the Pi and make the responses as detailed in red in the instructions document, to do the setup.
Looking at your screenshot (presumably made from your original PAW groundstation) I guess it thinks your OGN station (note, N for network!) is in Coventry, which is the default setting. When you run through the setup responses you will change the location using the Schellenberg site (see start of “Shellinabox” section of the instructions).
I hope this helps.
Regards,
Chris