I use serial connection to Dynon Skyview and have recently upgraded from Classic to Rosetta and fitted external aerials.
On Classic, never had a problem but on the Rosetta, the link drops every five minutes or so. It usually reconnects after a little while, only to drop again. Each time Mrs Dynon yells at me and it's a real pain.
Point taken about cables but the timing of this and intermittent nature suggests to me that I have a different problem.
Are the configuration parameters the same for the Rosetta as the Classic? I can't see why they would be different but maybe faster processor needing faster baud rate or something like that? I'm using 'Alarm-OUT' with 57600.
In addition to the baud rates, are there any settings other than alarm out specified?
Is it USB at both ends, or is there a USB/Serial involved?
What about things like parity, flow control, etc? Does the serial port in the Rosetta need further config?
What does the Dynon require? At the risk of sounding lazy, I'm not motivated to go through 500-odd pages of Dynon manual in PDF on a screen to locate the settings, can you find and post them here?