Hi Bob,
Good to know you have found the problem. First point of contact is Ash at PilotAware Support, e-mail
support@pilotaware.com .
If out of warranty and not keen to have a go yourself, I’d certainly suggest taking up Jeremy’s offer - he makes the Charge2 and Charge4 aviation power supplies, so knows what he is doing.
Alternatively, if you are keen to have a go yourself, and if the socket isn’t too badly deformed, you should be able to fix it yourself
if you are careful - see my post from a recent thread here...
http://forum.pilotaware.com/index.php/topic,1871.msg20036.html#msg20036As you will see from the earlier post, I recently had to fix the socket on my original Rosetta Prototype - which has now been in extensive use as a ‘test bench’ for several years. And as it happens I also had to fix another fairly new one with the same problem (in his case user induced) for a colleague last Sunday. If you decide to have a go, take your time and squeeze carefully.
To do so, you need to take off the antennas and remove the nut holding the Bridge into the upper case
and remove the microSD card and the dongles from inside the cover at the other end, then carefully split the case apart by finding and gently pressing the connecting clips inward with a thin knife blade (or a strong thumb nail) - there are two clips at each side of the case. I suggest finding those on the power socket side first - one between the power and HDMI socket and the other midway between the audio socket and the case end. Once located, it only needs gentle but firm pressure through the seam to pop the clips - as soon as the case starts to open, stop pressing or you may break the clip off. Once you have split the case at both sides, slip the upper case off the Bridge antenna socket then gently ease the two joined boards out of the case (the Raspberry Pi is clipped into the case at both sides but can be removed by gently easing the case sides away from the board. Be
very careful if you decide to separate the Bridge from the Motherboard. You
must pull the Bridge straight up to separate them or you will bend the GPIO pins.
In either case, you now need to
gently close the gap between the upper and lower faces of the socket by squeezing very gently but firmly with small pliers - using a small bit of cardboard between the lower jaw of your pliers and the underside of the PCB and being careful to squeeze the
outside edge of the socket, not too far back. Take it in small steps and keep checking the fit of the plug - if you squeeze too hard you may not be able to go back and will need a new socket or (worst case scenario) new motherboard!
Regards
Peter