Unable to load latest update.

[EricC]

Yes.
Linux
192.168.1.14
192.168.1.3
192.168.1.6
Server
192.168.1.8



.

[AlanG]

Hi Eric

I can only suggest you try inputting the IP addresses one at a time in the format http://192.168.1.14:4200 into the top url address bar of your browser and see if one of them takes you to the ognpaw Login.

If so enter pi  then press enter,  when prompted for password enter 12345678 then press enter.  Dont forget you will not see any response when you are typing in the numbers so just be careful to hit them in order.

If successful you should then be able to run the configuration file.

Hope this helps
Alan

Edit:
Eric, if you still cannot get in after trying this please tell me who your internet provider is and if possible any info about the router you have.  look for a label on the back or bottom of the router.

Alan

[EricC]

Provider is TalkTalk-00F0E3
D-Link-3680 wireless N150
ADSL2+ ROUTER
P/N ESL 3680BTTF.A1E
I will check if I have another router to try.
I would not connect.

Thanks. EricC

[EricC]

Just tried my mobile with the address.... Failed to connect.

[Admin]

Hi Eric

I think we need to go back to basics

Can you connect a keyboard and hdmi monitor?
Sounds like a potential networking issue

Thx
Lee

[EricC]

Yes

[EricC]

all connected    Rasbian GNU/Linux  9  raspberrypi tty1
raspberrypi login:

[Admin]

Hi Eric
Now follow the regular OGN installation instructions

Thx
Lee

[EricC]

typed..pi and password nothing happens

[AlanG]

Eric, when you type in   pi   and press enter does it then change to ask for password?

Alan

[EricC]

yes    typed 1 to 8 nothing. this is normal. yes changes from login to password
this is the problem i have had since last update.
Peter sorted out this problem a few months ago

can you gain log on to my system?

[AlanG]

So when at password and you type in   12345678 your saying nothing happens.
I am assuming that you have are trying to upload the latest software from a newly prepared  SD card and not trying to access your original version as set up with Peter's assistance.  If it is the latter that you are trying to do then your password will be the one you set up with Peter,  your station name plus the number 1.  all in lower case letters.

sorry Eric , I didn't see your edit until after I posted.  No I don't know how to log into your system, there are things you would have to do to the router to allow someone to do that and I've been looking at your router specs and not sure if it can be done.

Alan

[EricC]

Down loaded the latest update onto a formatter 4 new micro sd card now in the paw
i an aware of the station name plus one.
i have tried both  pi   poulton1   pwpoulton1

[AlanG]

Hi Eric

I'm now running out of ideas.  As you say it's a completed new download then the password should definitely be 12345678.

have you still got the card with the original version and can you try this in the station to see if this still works.  if it does then depending on the version it may be possible to do a manual update over the internet.  Will need Lee to confirm this.

Alan

[EricC]

Sorry been formatted by formatter4.